{
    "base_id": "GFSA04",
    "chamber_temperature": [
        "45"
    ],
    "enable_pressure_advance": [
        "1"
    ],
    "epoxy_resin_plate_temp": [
        "0"
    ],
    "epoxy_resin_plate_temp_initial_layer": [
        "0"
    ],
    "fan_cooling_layer_time": [
        "60"
    ],
    "fan_max_speed": [
        "40"
    ],
    "fan_min_speed": [
        "10"
    ],
    "filament_cost": [
        "29.95"
    ],
    "filament_density": [
        "1.23"
    ],
    "filament_max_volumetric_speed": [
        "11"
    ],
    "filament_notes": [
        "Created on 5/27/26 @ 11:29am from K2 Plus profile"
    ],
    "filament_retract_before_wipe": [
        "100%"
    ],
    "filament_retract_when_changing_layer": [
        "1"
    ],
    "filament_retraction_length": [
        "0.4"
    ],
    "filament_settings_id": [
        "3D-Fuel PCTG Pro @Creality K2 Pro 0.4 nozzle"
    ],
    "filament_type": [
        "PCTG"
    ],
    "filament_vendor": [
        "3D-Fuel"
    ],
    "filament_wipe": [
        "1"
    ],
    "filament_wipe_distance": [
        "2"
    ],
    "from": "User",
    "hot_plate_temp": [
        "80"
    ],
    "hot_plate_temp_initial_layer": [
        "80"
    ],
    "inherits": "Generic PETG @Creality K2 Pro 0.4 nozzle",
    "is_custom_defined": "0",
    "name": "3D-Fuel PCTG Pro @Creality K2 Pro 0.4 nozzle",
    "nozzle_temperature": [
        "260"
    ],
    "nozzle_temperature_initial_layer": [
        "260"
    ],
    "nozzle_temperature_range_low": [
        "250"
    ],
    "overhang_fan_threshold": [
        "95%"
    ],
    "pressure_advance": [
        "0.105"
    ],
    "required_nozzle_HRC": [
        "3"
    ],
    "slow_down_layer_time": [
        "18"
    ],
    "slow_down_min_speed": [
        "15"
    ],
    "temperature_vitrification": [
        "84"
    ],
    "textured_plate_temp": [
        "80"
    ],
    "textured_plate_temp_initial_layer": [
        "80"
    ],
    "version": "26.4.28.19"
}