{
    "bridge_speed": "20",
    "brim_type": "no_brim",
    "enable_extra_bridge_layer": "apply_to_all",
    "enable_support": "1",
    "from": "User",
    "gap_infill_speed": "100",
    "inherits": "0.10mm Color Mixing @Snapmaker U1 (0.4 nozzle)",
    "initial_layer_infill_speed": "80",
    "inner_wall_speed": "100",
    "internal_bridge_speed": "100%",
    "internal_solid_infill_speed": "70",
    "is_custom_defined": "0",
    "mixed_filament_definitions": "1,2,1,0,50,0,g,w,m2,z0,xa0,xb0,d0,o1,u21;1,3,1,0,50,0,g,w,m2,z0,xa0,xb0,d0,o1,u22;1,4,1,0,50,0,g,w,m2,z0,xa0,xb0,d0,o1,u23;2,3,1,0,50,0,g,w,m2,z0,xa0,xb0,d0,o1,u24;2,4,1,0,50,0,g,w,m2,z0,xa0,xb0,d0,o1,u25;3,4,1,0,50,0,g,w,m2,z0,xa0,xb0,d0,o1,u26",
    "name": "3DF PCTG - 0.10mm Color Mixing @Snapmaker U1 (0.4 nozzle)",
    "outer_wall_speed": "50",
    "print_settings_id": "3DF PCTG - 0.10mm Color Mixing @Snapmaker U1 (0.4 nozzle)",
    "sparse_infill_speed": "100",
    "support_interface_spacing": "0.1",
    "thick_bridges": "1",
    "top_surface_speed": "50",
    "version": "2.2.56.2"
}