John-Schneider
- Total activity 48
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 30
Activity overview
Latest activity by John-Schneider-
John Schneider commented,
ConnorB, Which Prusa printer are you looking for a profile? We may be able to build a profile for a specific printer. Otherwise, I recommend that you start with a PETG profile and set the hotend te...
-
John Schneider commented,
Jon Fernandez, I recommend the Bambu Lab Engineering print surface. Or, if you use PEI, make sure to use glue stick as a release agent otherwise it will stick too well.
-
John Schneider created an article,
Pro PCTG Print Profiles
These in-house developed print profiles are an excellent starting point for printing with our Pro PCTG. If you find a better setting for your 3D printer with our materials, please let us know, and ...
-
John Schneider created an article,
Standard PLA+ Print Profiles
These in-house developed print profiles are an excellent starting point for printing with our Standard PLA+. If you find a better setting for your 3D printer with our materials, please let us know,...
-
John Schneider created an article,
Tough Pro PLA+ Print Profiles
These in-house developed print profiles are an excellent starting point for printing with our Tough Pro PLA+. If you find a better setting for your 3D printer with our materials, please let us know...
-
John Schneider created an article,
Information on our composite line from c2renew including Entwined™ Hemp, Wound Up Coffee, Buzzed Beer Glass Filled PLA
3D-Fuel led the 3D printing community with some unique products that have experienced quite a following over the years. We receive numerous questions about these products - this aims to answer most...
-
John Schneider created an article,
How to request assistance with a possible defective spool of 3D-Fuel filament
If you are experiencing issues with a 3D-Fuel product, we want to help! We are typically available between 9am and 4pm via the livechat on our website and phone number. But sometimes you need help ...
-
John Schneider created an article,
What is the difference between Standard PLA+ and Pro PLA+?
Pro PLA+ was developed from the ground up for 3D printing. It is tougher, stronger, has a higher heat resistance, and better layer to layer adhesion than Standard PLA+. But first, a little bit of ...
-
John Schneider created an article,
Standard PLA+ Print Recommendations
Recommended Print Settings: Hot End Temp: 190° - 210°C (Start at 200°C) Heated Bed Temp: 0-60C (heated bed not required) Bed Surface: Bare acrylic, blue painters tape + hairspray, glass + hairspra...
-
John Schneider created an article,
Does your 2.85mm filament work in an Ultimaker?
Yes, our 2.85mm filaments are compatible with Ultimaker 3D printers.