Jim
- Total activity 10
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 1
Activity overview
Latest activity by Jim-
Jim commented,
Ok, I fixed nearly all of the issues with the blobbing using retraction settings: I'm still tweaking, but I've blown about 80 bucks on your filament trying to get them this good. Not an easy task. ...
-
Jim commented,
Ok. I tried the new one and it was a big improvement. Unfortunately, there are still some issues that I can't seem to resolve, but we're getting closer. But I cannot figure out what is causing thes...
-
Jim commented,
Hey John.. What outer/inner wall speeds did you use with this profile?
-
Jim commented,
I bumped it up to 15 and started to get little hairs again.. so I think somewhere between 10-12 is good for me.
-
Jim commented,
I had mine set to 10. my new prints came out 99% perfect. No stringing at all between models and maybe only one small blob.
-
Jim commented,
So my changes worked for a single print, then I started getting A LOT of stringing when doing multiple models at once. I ended up using the settings overrides found here: https://forum.bambulab.com...
-
Jim commented,
I'm using a Bambu P1S. I literally just tried lowering the nozzle to 255 and the prints are a lot better at print speed of 200. Bed is still at 70 with a textured PEI so things stick pretty good. W...
-
Jim commented,
Having the same problem as Grant, above. Lot's of blobs in the middle of the model. Can't figure out the proper configuration.